Pharos iMFP and Sentry Supported Devices

The following pages are updated frequently. Each page lists the manufacturer's device models and the Pharos software that supports each device. These lists apply only to Pharos iMFP and Sentry Print support. If you are using a Sentry SR25 or Omega terminal, any device is supported.

• HP

• Canon

• Lexmark

• Ricoh

• Konica Minolta

• Sharp

• Toshiba

• Xerox

Download Updated Software

Pharos iMFP software and documentation 

NOTE: The "Documentation" link below is for the primary deployment/installation of the software. For full documentation, download the software.

• Sharp v2.6.5.1

• Xerox v3.0.4     Documentation

• HP Product Suite 1.0.26     Documentation

• Konica Minolta v2.2.11     Documentation

• Ricoh v1.5.10     Documentation

• Canon v3.4.2    Documentation

  • For the US & The Americas

  • For Europe, the Middle East, & Africa

  • For Asia & The Pacific  

• Toshiba eConnector

  • For Blueprint v11.13

  • For Uniprint v1.14

  • Toshiba eConnector Service Guide

Download Omega and SR25 Firmware

• Pharos Sentry Base Service v2.0.6.14627 (required for SR25 in Blueprint and Uniprint)

• Pharos Sentry SR25 Firmware v1.0.1.12176 (for sites with BPDU Protection) (1)

• Pharos Sentry SR25 Firmware v1.0.1.12202 (for sites without BPDU Protection) (2)

• Pharos Omega PS200ET v1.1.0.151

• Pharos Omega PS200 v1.0.1.11749

• Pharos Omega PS150 v2.2.2.11651

(1) - Networks utilizing Bridge Protocol Data Unit (BPDU) Protection may run into problems with the SR25's BPDU and cause the device to block. This firmware can be used to prevent that problem.

(2) - This firmware version enables the SR25 switch for Spanning Tree Protocol (STP).